Griffe

1. One-piece molding to prevent rain and dust from entering the internal corrosion parts, longer service life and safer 2. Built-in intelligent temperature control chip, three-speed adjustable temperature, intelligent temperature control is safer 3. 12V voltage, 22MM handlebar inner diameter, suitable for most motorcycles 4. Double throttle cable buckle, wider installation range 5. The design can be sealed and can be opened, which does not affect the installation of the handle outside the handle, and only the lights and other decorative accessories are installed, which is more beautiful and convenient 6. The product has added a standby mode. After switching to the standby state, the electric heating handle will automatically maintain a constant temperature of about 50 degrees, and it will automatically shut down after two hours. You dona??t have to worry about running out of the motorcycle battery because you forget to turn off the switch. 7. Applicable models: 12V motorcycle with a handlebar diameter of 22mm 8. Handle temperature: low temperature 40 degrees Celsius, medium temperature 50 degrees Celsius, high temperature 60 degrees Celsius Installation notes: 1. First remove the original handlebar with tools, and then clean the original handlebar 2. Then moisten the inner holes of the left and right handles of the product with soapy water respectively, and install the left and right handles on the handlebars of the original car separately. 3. When installing the right handlebar, the power cord should be left enough for rotation to facilitate the rotation of the accelerator 4. Fix the S bracket on the handle of this product to the position where the handle has screws, and fix the wire on the bracket to avoid shaking the handle wire and reduce damage 5. The red wire of the product power cord is connected to the positive pole of the power supply of the car, and the black wire of the product is connected to the negative pole of the power supply of the car. 6. Because this product has two fixing methods (rearview mirror fixing, 3M glue fixing), you can fix the aluminum alloy switch to the L bracket with small screws, and then fix the L bracket to the rearview mirror base and tighten it; or directly Use 3m film to stick to the back of the aluminum alloy switch, and then stick the 3m glue to a suitable position on the car to fix it. Precautions: 1. When installing the left handle, do not twist the handle too much. Excessive twisting will cause the heating wire to shift 2. For models with balance iron, please adjust the installation position of the balance iron. Do not squeeze the handle when tightening the screws. The balance iron is slightly separated from the handle. If the installation position of the balance iron cannot be adjusted, please add a spacer between the balance iron and the handle. Excessive squeezing of the handle will cause difficulty in turning the handle switch and abnormal damage such as the heating wire squeezing out of the handle surface.Specification: Package Weight One Package Weight 0.37kgs / 0.80lb One Package Size 20cm * 13cm * 6cm / 7.87inch * 5.12inch * 2.36inch Qty per Carton 40 Carton Weight 15.78kgs / 34.79lb Carton Size 40cm * 39cm * 42cm / 15.75inch * 15.35inch * 16.54inch Loading Container 20GP: 407 cartons * 40 pcs = 16280 pcs40HQ: 944 cartons * 40 pcs = 37760 pcs

Lesen Sie Mehr Weniger

1. Input voltage: DC12V 2. Product line length: 108CM (heating film to switch), 146CM (switch to electric door lock) 3. Working temperature: -30 to 100 degrees Celsius 4. Product power: 20W, 15W, 10W 5. Product material: composite fiber heating wire + Kevlar wear-resistant cloth, (L bracket) stainless steel 6. Product accessories: 3M glue*1, cable tie*5, stainless steel L bracket*1 7. Installation method: 3M glue sticking and fixing, L bracket lens holder fixing 8. Wiring method: red connect to the positive pole, black connect to the negative pole (the lamp does not turn on when the connection is reversed, and only heats up) 9. Operating instructions: power on: red light, blue light and green light each flash once and then go out 10. Standby: the red light flashes in breathing state, the temperature reaches a certain temperature and it will automatically turn into a blue light 11. Click the power button: switch gears 12. Note: the positive and negative poles are connected reversely, the switch cannot be used, and the heating element directly heats up Product advantages: 1. Kevlar material, heat up faster, heat more evenly, after 8000 times abrasion test successfully 2. Built-in intelligent temperature control chip, three-speed adjustable temperature, intelligent temperature control is safer 3. 10 seconds rapid heating, large heating area 4. The heating sheet is fixed by hook and loop fastener, which is convenient and quick 5. IP67 waterproof level, even if the switch and handle cover are soaked in water, they can work normally. When the handle cover needs to be cleaned, only unplug the plug and wash with water, which is very convenient Pay attention: 1. Please select the appropriate gear according to the ambient temperature. Under low temperature conditions, if the temperature of the electric heating grip cover cannot be sensed in time due to the numbness of the hand, please use the low or medium gear first to prevent high temperature burns. 2. This product is only suitable for motorcycles with 12V battery. Please read the installation diagram carefully before installation. Incorrect wiring will cause damage to the components. 3. This product can only be installed on the handlebars of motorcycles when it is energized. You can use a battery to test whether the product is properly energized before installation. 4. It is strictly forbidden to energize and work when not riding (empty burn), in order to prevent the temperature of the electric handle cover from being too high and damaging the original handlebar 5. It is recommended to connect the electric door lock cable to the wiring. Most models have black positive pole and green negative pole. For specific conditions, it is recommended to use a multimeter to measureSpecification: Package Weight One Package Weight 0.16kgs / 0.35lb One Package Size 13cm * 4cm * 17cm / 5.12inch * 1.57inch * 6.69inch Qty per Carton 80 Carton Weight 13.90kgs / 30.64lb Carton Size 52cm * 40cm * 34cm / 20.47inch * 15.75inch * 13.39inch Loading Container 20GP: 377 cartons * 80 pcs = 30160 pcs40HQ: 875 cartons * 80 pcs = 70000 pcs

Lesen Sie Mehr Weniger

1. High quality material and long service lifeSpecification: Package Weight One Package Weight 0.19kgs / 0.43lb One Package Size 10cm * 8cm * 5cm / 3.94inch * 3.15inch * 1.97inch Qty per Carton 100 Carton Weight 23.10kgs / 50.93lb Carton Size 42cm * 42cm * 27cm / 16.54inch * 16.54inch * 10.63inch Loading Container 20GP: 559 cartons * 100 pcs = 55900 pcs40HQ: 1299 cartons * 100 pcs = 129900 pcs

Lesen Sie Mehr Weniger

1. PVC material, high temperature resistance2. Unique design, excellent performance3. Easy to install and remove4. Different colors, match freely5. Weight: 40g / pairSpecification: Package Weight One Package Weight 0.05kgs / 0.12lb One Package Size 15cm * 6cm * 3cm / 5.91inch * 2.36inch * 1.18inch Qty per Carton 100 Carton Weight 6.20kgs / 13.67lb Carton Size 32cm * 30cm * 30cm / 12.6inch * 11.81inch * 11.81inch Loading Container 20GP: 925 cartons * 100 pcs = 92500 pcs40HQ: 2149 cartons * 100 pcs = 214900 pcs

Lesen Sie Mehr Weniger

1. Simple design and easy to use 2. Installed on the vehicle: left, right, front 3. Suitable for most suitable for Honda, suitable for Yamaha, suitable for Suzuki, suitable for KTM, suitable for Polaris ATV, snowmobiles and motorcycles with 7/8" (22mm) handlebars. (As long as you can See the faucet on the motorcycle, you can usually install it) 4. Material: plastic 5. Width: 24cm 6. Height: 12cm 7. Weight: 140g 8. Package content: 2 * hand guard (including installation hardware)Specification: Package Weight One Package Weight 0.15kgs / 0.34lb One Package Size 25cm * 15cm * 5cm / 9.84inch * 5.91inch * 1.97inch Qty per Carton 97 Carton Weight 15.00kgs / 33.07lb Carton Size 30cm * 50cm * 50cm / 11.81inch * 19.69inch * 19.69inch Loading Container 20GP: 355 cartons * 97 pcs = 34435 pcs40HQ: 825 cartons * 97 pcs = 80025 pcs

Lesen Sie Mehr Weniger